I finished my self install a week or so ago (working on concrete deck right now) and the pool is level as well as the water the automation system works great but I'm concerned about my gauge readings at the filter.
When on low speed it stays on 0, never moves even after a 24hours of run time. When the pumps on high the filter gauge shows 10. When vacuuming the dirt,etc from the build it went as high as 30 then after back washing filter it went back down to 10(only on high speed, 0 on low speed)
The water is clear and the filter seems to be doing its job but wondering if it should be reading higher than 0 on low speed?
All plumbing lines are 2 inch as follows:
1 line to both main drains, 1 line to skimmer both to the jandy valve into pump
Return line goes from SCG to jandy valve then the lines are run to each return. 4 return lines with 2 on each side of the jandy valve ( each has an inline valve for servicing)
When on low speed it stays on 0, never moves even after a 24hours of run time. When the pumps on high the filter gauge shows 10. When vacuuming the dirt,etc from the build it went as high as 30 then after back washing filter it went back down to 10(only on high speed, 0 on low speed)
The water is clear and the filter seems to be doing its job but wondering if it should be reading higher than 0 on low speed?
All plumbing lines are 2 inch as follows:
1 line to both main drains, 1 line to skimmer both to the jandy valve into pump
Return line goes from SCG to jandy valve then the lines are run to each return. 4 return lines with 2 on each side of the jandy valve ( each has an inline valve for servicing)