Good afternoon! I just bought a house that has a 19 X 23 pool with an infinity edge. The system has two pumps - one that handles the single skimmer/main drain, and then the edge pump. I have read about the length of time to run the main pump. Are there special considerations for the edge pump run times - or, do you just run it for a fraction of the time, given that it has far less water to circulate? Certainly if there is a lot of swimming and thrashing then running the edge pump probably keeps the automatic water leveler from draining too much - so maybe turn on while swimmers are in there.
Just measured, and the basin beyond the edge is about 3 X 3 X 19 in dimension. This is a saltwater pool, as well, should point that out.
But as a baseline run time for the edge pump to set on the timer - run it less? same as the main pump run cycle? Just trying to optimize a little bit the utility side of things here!
Thanks so much,,,,
Just measured, and the basin beyond the edge is about 3 X 3 X 19 in dimension. This is a saltwater pool, as well, should point that out.
But as a baseline run time for the edge pump to set on the timer - run it less? same as the main pump run cycle? Just trying to optimize a little bit the utility side of things here!
Thanks so much,,,,