So I've been using this site the past couple of weeks and now with a whopping 3" of water in the pool I need help! 22' Intex ultraframe. Level site, 2x6x6 pavers placed with top ring and leveled, 1" insulation board with cutouts for pavers. Finally set the pool on it tonight and began filling.
Problem 1: Pavers appear to be too far out in a few places. Should I cut more instulation board and move them in. What should the legs look like vertically with 3" of pool water and also when it's full? I hate to move them but to pull the legs out to a few of them puts the liner in quite a bind and has the legs leaning a bit.
Problem 2: Where should the liner sit in relation to the pavers? The inside edge of a few of the pavers stick slight (1/8-1/4") above my insulation board and can be felt through the liner. Is this going to cause problems with the liner?
Thanks - my wife is getting quite impatient with the whole process and wants to get rid of the pavers. I know that's not the answer - but lining the legs up on them has turned into quite a pain. We've stopped filling for now until we get this figured out.
Problem 1: Pavers appear to be too far out in a few places. Should I cut more instulation board and move them in. What should the legs look like vertically with 3" of pool water and also when it's full? I hate to move them but to pull the legs out to a few of them puts the liner in quite a bind and has the legs leaning a bit.
Problem 2: Where should the liner sit in relation to the pavers? The inside edge of a few of the pavers stick slight (1/8-1/4") above my insulation board and can be felt through the liner. Is this going to cause problems with the liner?
Thanks - my wife is getting quite impatient with the whole process and wants to get rid of the pavers. I know that's not the answer - but lining the legs up on them has turned into quite a pain. We've stopped filling for now until we get this figured out.