I'm trying to clear up my pool before I add the cya just so I don't have to backwash the filter for the one week. Because I have no CYA currently, keeping a shock level of 10 is still fine for the liner and everything right? I mean you have shock of 15 when you are doing the baquacil conversion so I assume keeping it around 10 with no cya is ok until things clear.
Just some numbers from yesterday (only been using TF100 for about a week now so I think I'm getting the hang of it - almost addictive right now)
These were taken throughout the day - did not right down time.
FC CC
4 5
3 4
3.5 3
5.5 6
6.5 3.5
The last measurement was this morning. Not sure what my night reading was but maybe around 8 so I did not loose a ton over night. I have been no where near the 10 but the pool is still progressing and getting clearer. Obviously it is chewing stuff up as the CC are high. May still have some baquacil left but would have been trace amounts as I think I basically converted last fall but may have not finished completely. Water is just a little cloudy as I can see the deep end fairly clearly (6'). Seems like it has a yellow tint to it but this is getting better too.
PH was 6.8 and added 4lbs of borax. Next day still 6.8 so it was very low. Added another 4 lbs but have not checked yet. Alk is holding around 60. OH and using clorox for the chlorine. Thanks CostCo!!
Just some numbers from yesterday (only been using TF100 for about a week now so I think I'm getting the hang of it - almost addictive right now)
These were taken throughout the day - did not right down time.
FC CC
4 5
3 4
3.5 3
5.5 6
6.5 3.5
The last measurement was this morning. Not sure what my night reading was but maybe around 8 so I did not loose a ton over night. I have been no where near the 10 but the pool is still progressing and getting clearer. Obviously it is chewing stuff up as the CC are high. May still have some baquacil left but would have been trace amounts as I think I basically converted last fall but may have not finished completely. Water is just a little cloudy as I can see the deep end fairly clearly (6'). Seems like it has a yellow tint to it but this is getting better too.
PH was 6.8 and added 4lbs of borax. Next day still 6.8 so it was very low. Added another 4 lbs but have not checked yet. Alk is holding around 60. OH and using clorox for the chlorine. Thanks CostCo!!