- May 28, 2010
- 2
I am connecting a new Intex SWG to my old Clearwater sand filter system, the rated output of the original system is rated at 28000 gal per 8 hrs. The required rate for the SWG syatem is a min of 700gph.
Followed directions(?) and inserted SWG per the manual. Started the pump and waited an hour, then turned the SWG on and set the timer per the manual. After 2min the system started beeping and gave a digital warning of 90 and the flashing light on the Low Flow indicator.
Disconnected the SWG and cleaned and reconnected wires and hoses, and tried again with the same results
The pump/motor does not have a hp rating listed in the motor, only four stars (****). Fresh sand and cleaned out hoses and pump and back flushed. Strong return flow through the return system.
Has anyone else had this issue?
Thanks for your help
Lee
Followed directions(?) and inserted SWG per the manual. Started the pump and waited an hour, then turned the SWG on and set the timer per the manual. After 2min the system started beeping and gave a digital warning of 90 and the flashing light on the Low Flow indicator.
Disconnected the SWG and cleaned and reconnected wires and hoses, and tried again with the same results
The pump/motor does not have a hp rating listed in the motor, only four stars (****). Fresh sand and cleaned out hoses and pump and back flushed. Strong return flow through the return system.
Has anyone else had this issue?
Thanks for your help
Lee