I have a very slow drip at this fitting and see no way to DIY fix it. Anyone have any ideas?
Sure. Unless I am missing something, disconnect the pipe at the union and then the pipe going into the pump will unscrew from the pump body.Anyone have any ideas?
You can likely make it match.I guess the obvious answer is the elbow fitting would have to be re made up? Something i'm not sure i can do.
PoolGuyNJ said:The coupling has a divider inside that is about an eighth inch. If you make the cut in the pipe less than perfect, and that is normally the case is not done with a chop saw or miter, there will be some additional added length to the pipe due to the angled ends. This may require some minor trimming to shorten it.
Scott
PoolGuyNJ said:The concern is that if the existing male adapter needs to be threaded into the pump more than it was, this will change the hight at which the union ends line up. Adding a coupling on the vertical pipe would add that little extra height you might need.
Scott