Hy folks, while prepping for a party today, I went to fire up the pool heater. To my surprise, the RayPak wouldn't fire. Put it in spa mode, and it fired right up. Put the panel in service mode, flipped the switch on the heater on and put the thermostat to high, and same result. No fire in pool mode, switch to spa and it fired right up. Any ideas?
RS4 not heating pool
- Thread starter Jamann
- Start date
Sounds like a bad rheostat on the board. Seeing that you have a control system, it doesn't matter if you use the "pool" or the "spa" button. Either of them will heat the water to you set temp per your automation system. So if it works on the "spa" side, well then you should have a warm pool.
You have an old versa unit and at some point it will need to be replaced.
You have an old versa unit and at some point it will need to be replaced.