No lights on SWG

[Deb04]

Reposting in SWG forum instead of equipment in the hope of getting advice.

Trying to get our IC-40 going for the first time this season. No lights on the Ic-40 are on. All circuit breakers are on.

What am I missing? This is my set up.

 

[Griswald]

You need flow.

 

[Jimrahbe]

Deb,

If you have "no" light then the SWCG is not getting power from its power supply.

I would suspect the fuse in the bottom of the power supply enclosure.

Your pool builder did you no favors installing it that low to the ground as it will be pain to get to..

If the fuse is good and you have AC power getting to the power supply then you would need to check the DC voltage in the power supply that is being sent to the cell. Should be about 35 volts or so...

Thanks,

Jim R.

 

[Philo]

I really don't see the power cord going from the SWG to the bottom right side of the power supply??

 

[Shekkie]

I really don't see the power cord going from the SWG to the bottom right side of the power supply??

Correct. It looks like it is behind the conduit just under the power unit.

 

[Philo]

Correct. It looks like it is behind the conduit just under the power unit.

Now she just needs to plug it in to the power supply.

 

[Flying Tivo]

Yea, just plug it in! Make sure the power supply is off first!

Felipe