I'm going to be replacing my current pump (see signature below for my complete setup) in hopes of getting better filtration for my 18x52 above ground pool. Due to it only having one skimmer and one return I feel as if I need to increase my hp as my return doesn't move my water (in my uninformed opinion) as much as I think it should. Although my pump is currently working, it is noisy and has a small leak where the housing of the impeller is located. Also according to my pressure gauge (purchased last year) I'm only running 3-5 psi when filtering. That seems low to me but its been consistent since getting this pool. Since I'm not the original owner of this pool I have no knowledge as to its age or if it has the proper hp as compared to the sand filter rating of 45 gpm flow rate. Lastly, is there some type of standard as to the motor mounting hardware that I will need to know when making my selection so that it will fit my current bolt pattern on the base?
While I do want to be frugal with my purchase I don't want to let the cost be the sole factor in making my decision. I welcome your thoughts and comments as I know there are a lot of choices out there.
Fill me with your knowledge Pool Masters !
David
While I do want to be frugal with my purchase I don't want to let the cost be the sole factor in making my decision. I welcome your thoughts and comments as I know there are a lot of choices out there.
Fill me with your knowledge Pool Masters !
David