The new Pentair WhisperFlo 2-speed pump motor has arrived this afternoon, and to my surprise, the new 2-speed motor comes with a speed toggle switch already installed. I am planning to use the Hayward Aqua Plus automation to control the new 2-speed pump.
I have a feeling that I need to remove the toggle switch before wiring to the Hayward Aqua Plus. Before doing anything to the new motor, I spent couple hours in researching the subject of wiring 2-speed pump w/toggle switch to an automation system on TFP forum, but I could not found any answers.
Please help me with the following issues:
Thanks for the help in advance.
I have a feeling that I need to remove the toggle switch before wiring to the Hayward Aqua Plus. Before doing anything to the new motor, I spent couple hours in researching the subject of wiring 2-speed pump w/toggle switch to an automation system on TFP forum, but I could not found any answers.
Please help me with the following issues:
- Do I need to remove the speed toggle switch before wiring to the Hayward Aqua Plus?
- If the toggle switch does not need to be removed, at what speed position (Low or High) should I place the toggle switch?
Thanks for the help in advance.