Is there just 1 wire coming from the fireman's switch? My Raypak P-206A manual says to splice into the red jumper wire on the multi-pin plug that goes to 2 pins.
Thanks
There should be two wires. It may be a loop of wire that you cut and connect to the fireman's terminals, but once connected correctly, there will be two wires.
Thanks for the reply. I haven't received the new timer module, yet and can't find any pix of the connections. That makes sense as my Raypak heater has a loop between 2 pins, so I can connect 2 wires when I cut it. I think it is low voltage so I should be able to run 2 small guague wires for the fireman's switch.
It's just a input to the control circuit of the heater telling it that the pump isn't running so it ensures a shut down and it's not solely depending on low flow (actually pressure) to shut it down, so small wiring should be plenty.
Hello , This thread has been inactive for over 60 days. New postings here are unlikely to be seen or responded to by other members. For better visibility, consider Starting A New Thread.
Welcome to TFP! For a wealth of pool care information please check out our free Pool School. If you are in need of specific help then we encourage you to Register and ask us here in the forum!