intelliph

Just installed a Pentair Intelliph system with my Easytouch and IC40 SWG. Pool automation is working fine but when I powered up the Intelliph system for the first time, it said no dispensing due to spa mode. I switched the system to spa and it started dispensing so somehow intelliph sees my...

I recently had to replace my Intellichlor after it started tripping the small breaker on my Easytouch. I initially had trouble with my new SWG not making enough chlorine, but figured that out with y'all's help (chlorine level was too low to catch up). Now I have an issue with my IntellipPH...

I just experienced a failure of a Pentair Intelliph (acid dispenser) control board, and I plan on replacing it with a home-brewed "Arduino" microcontroller-based board. Two diodes, D3 and D4 appeared fried on the native board. I don't know their function, but they may be supplying DC power to...

Does anybody recall seeing any threads regarding the automation of a stenner pump (Acid or Chlorine)? I think that I have seen some here in the past but I have been searching for a while now and no joy. Looks like my dumb IntellipH, listens on the bus (according to some conversations that I saw...

I became curious about the whole "manual dosing" thing with the IntellipH. The manual states that "approximately 4 oz of acid will be dispensed within the 60 seconds of the manual dosing cycle. Well, to me, that is a bit ambiguous, since the MA is normally diluted by 50%. So, it got me...

Based on the advice and suggestions of so many here on TFP, I have made the decision to install the IntellipH versus the IntelliChem. I really like many of the IntelliChem features with integrating with automation and all, but I guess my main concern is with the ORP reading issues with pools...