Search results

I realize this thread in approaching two years old...but if you are still around, would you let us know the outcome of this? Thanks

Hi, I replaced my sand filter with a cartridge filter at the beginning of this season and had to battle noise. The noise is basically the base acting as an amplifier of the motor vibration. Both were combo units with base - actually, I am pretty sure the bases are identical but never had a...

I started getting a slight "chatter" sound at startup towards the end of last season. The sound went away after a few seconds. It has been online this season for about 3 weeks and is now lasting 10-15 seconds. The colder it is the longer it lasts. Now it has developed a single drip below the...

No, it is solid - seems to be made out of same material as the tank. Yes! It is tape I just went to look at again after coffee and with my good glasses on and the sun up :cool::coffee: Thanks - I can sleep tonight!

This was in the bag with the pressure gauge and air relief valve of a Pentair C & C filter. I don't see mention of it in the manual nor do I see it on the parts diagram. Thanks

I would guess the first step in troubleshooting the salt cell situation would be to get a salt test kit and see if it tests close to what the cell is saying. K-1766 Taylor Salt Test As far as your pump, if you want to save some $ and don't want to tackle a DIY repair, try to find an electric...

To make it easier to insert and for older pipe less likely to split. A side effect is that it does mold somewhat as well. I have actually repressurized a poly pipe after removing the clamps out of curiosity and it held without leaking. That was breifly fooling around, no idea how long it...

I just heat the outside. A safer alternative for the inexperienced and a one time shot is to use boiling water either poured over the poly or put the end of the poly in the container holding the hot water.

I don't have a lot of pool experience, but I do have quite a bit of poly/barb fittings experience... I would suggest gently heating the poly prior to inserting the barb. I personally use a torch to do this, but you have to be careful not to melt it. I would also suggest using two clamps on...

I had a similar situation with my AGP - not sure if I would call the noise a "swoosh" though. It was the return causing a vortex in the pool and it would occasionally suck air and make a noise. Adjusting the eyeball would only move where the vortex was forming. I used two elbows to lower the...

Here is my experience with them - could be a fluke - I would recommend reading as many reviews as you can find. Hayward pump union threads same as Extreme power?

I didn't take measurements, but I have a Sta-Rite (Pentair) Dynamo 1.5 single speed. I bought an ExtremePowerUS 1.5 two speed to take advantage of having two speeds and have my current pump as a spare on hand. This was the only 2 speed pump I could find this summer. It took a month to get...

A search of the forum finds lots of things made by Waterway, but hardly anything about pumps. This one looks interesting to me - it is variable speed, can run on 115v, has the mount on the motor so it should fit onto my filter/pump stand and is cheaper than most others. Anyone heard any horror...

This is by far the cheapest and easiest solution I have found. This pump is identical to mine except it is two speed. I didn't mention it above, but I stupidly used 12-2 instead of 12-3 cable so add another $200ish for more cable and a 2 pole GFCI breaker for any 220v solution. My...

My wife is compaining about the noise level of the 1.5 HP single speed pump that came with our AGP. After reading about methods of noise abatement, it looks to me like the best solution is to get a VS pump. I first became interested in a V-Green 1.65 HP thinking I could just swap it with my...