Search results

Hi All! I'm having the same issue to. Its October 17th. It was working before but now just says "controller is offline" Is there a trick i need to do to get it working? Thanks!

Hey @ajw22 just an update i figured it out! For some reason the heater was duplicated in the system. So it was turning it ON and then OFF because it was getting confused which one to turn on! Thank you soooooo much for your help!! I couldn't have done it without you. Now I'm onto the valve...

The electrican is here. Its connected to a separate 240V breaker. It was initially on a relay.

Its night here now and i can see the display better. it says error AFS very briefly and then turns "off" but the blower continues to work. Confused as when i disconnect the OMNI and reconnect the firemans switch, the heater works. Your friend @ChrisLPC suggested using a different gauge of wire...

Thanks! Its a 8 ft long wire. 18 gauge wire. Maybe ill try it with 22. Im getting error AFS (which to my knowledge is blower motor not working, which it is), and when i discount the wire to the omni board and connect the firemans switch together it works. So maybe you gauge wire solution is what...

The fireman switch is getting 27 volts (my electrician just checked)

Could it be the settings in the config menu for the heater? right now its set to OPMLP.LVR1. Is that correct based on my set up?

Does the blower begin running? yes the blower begins running. Are there any error messages on the heater panel as it starts and does not run? no error message just turns off When it ignites how long does it run for? 5-8 seconds Says that on the heater display? Yes. When it starts up it says...

Okay! So i did everything and i can start it from the app. it starts up. Says Version 1.00. Then says SPA 79 and SET 104. The heater blinker starts blinking, and then it shuts off. Sometimes it will ignite, other times no. Are my wires inside where the firemans swtich are maybe reversed?

Turn off the heater breaker with the spa running at 104, or? Turn it off on the panel and then turn off the circuit breaker? Sorry, im a first time pool owner. frustrating for you.

Hi! When you say "If it was OFF then you need to turn it ON." what do you mean? I have the mastertemp running now in spa at 104. Do i turn off the heater and turn off the breaker and then reattached the two wires to the firemans switch?

Hello! Thank you.. Just to confirm i have a spa and also a pool that both use the same pump and heater. So turn off the circuit and reconnect the wires at the heater to put it back on local control..... Then it will power up and you set its controls to SPA and 104. .... Then turn off the...

Yes sorry lol youre right. One cable with two wires

Hi. I did not set the MasterTemp into SPA mode and a temperature of 104F on its control panel before i connected the Fireman's switch to the Omni. Is this a big error? How do i do this?

Hi. I did not set the MasterTemp into SPA mode and a temperature of 104F on its control panel before you connected the Fireman's switch to the Omni. Is this a big error? How do i do this?

I recently installed a Omnilogic upgrade kit on an old aqualogic system. Everything went good except im having trouble configuring the heater 2022 Pentair Mastertemp 400. I have one cable with two wires plugged into LV1 heater on the OMNI board (But i think im missing another communication...

Hi! We just bought a house with a pool, and have never owned one, so excuse my ignorance when it comes to pools! Our pump has recently quit, we tired to replace the capacitor, and it looks like its the bearings. I've been told its very costly to replace the bearings/motor, so we have decided to...