Search results

The spa switch is causing the control panel to lock in spa mode when a couple of the buttons are pressed. Only restoration is power cycle. Only happens when I use the One touch when the spa switch is connected. Remove the spa switch and everything is OK. Really the spa switch needs...

Looking to power a remote WiFi switch from a Jandy AUX (RS4 with 2 spare AUX). I’ve read the Jandy manuals, and while can see relays drawing 100mA the note also shows the 2 speed relay consuming 200mA. Want to know how much current can I source without blowing the driver chips? The device I...

Appears the motor drive electronics in my VS-FHP have failed. The unit is 7 years old. Motor has power (confirmed), iAqualink shows Priming on my phone screen but rpm = 0. Using the iQPUMP01 to force the motor on doesn't change anything. When I removed the lid, the inside electronics were...

Fixed (I think). This is an APP/FIRMWARE UPDATE REQUIRED issue. The pump started once the update was requested. A little frustrating the iqpump01 "Quick Clean" did not function (basically the iqpump01 buttons were fully functional but without the app nothing works). I started to tear apart...

My system did not start this morning. Use iAqualink to iqpump01 to control the pump and One Touch to control everything else. The App kicks back an error with "Multiple RS485 Devices" title and "Error: Multiple RS485 devices appear to be connected to the pump. Only one RS485 device can be...

I checked for shorts along the RS232 cable, but that's OK. Followed your instructions but the screen was still showing *Remote Enabled* after disconnecting the 2 center wires (keypad is still dead except for the lock feature). There's nothing connected to the remote terminals. Suspect the...

My 3 year old JEP-R keypad has become non-responsive (other than key-pad lock/unlock). It still runs the current program so my pool is functional, but I can't change anything or initiate any of the manual higher speed programs (such boosting speed to 3k for a minute when I turn on the rooftop...

Let me re-try this post: For anyone interested I purchased the Jandy FloPro. Here's some observations. My equipment is almost 100' away from the skimmer and the solar heating is 30' up on the 2nd story roof. I'm using the Jandy supplied JEP-R controller with old 2005 Aqualink RS system. It...

For anyone interested I purchased the Jandy FloPro. Here's some observations. My equipment is almost 100' away from the skimmer and the solar heating is 30' up on the 2nd story roof. Slowest adequate speed = 1250rpm

Well a fuse fixed it for now. Let's see how long it lasts... Thanks Mark

This morning there were no lights (presume no power) on my 8 year old ClevaChlor RPC30 system. Before I start dismantling anything are there any fuses or other 'typical' failure points on this system? If the problem is more than a loose wire/fuse. Given the cell is 8 years old, nigh on...

Split off of this topic. JasonLion I'm looking at the same pump comparison. Have a RS2/6 so theoretically could go either way Jandy FloPro, use the OneTouch of on/off and the controller on the pump for variable flow or Pentair + Intellicom + 2 relays. I'm leaning towards Jandy for...