Search results

The tall one gives ya a great massage therapy. The other one helps to cool the water. :-D

I used a PVC union so I can have different fountains, depending on the mood. :-D

Almost there

Plumbing :-D

More

More pics...

Hi, I'm new to this forum and I have to say I've learned a lot from it. Just wanted to share my setup. I hope I can build an in ground in the near future. But for now, this setup makes a great addition to cool down and relax from work. Here are some pics of the ground prep, plumbing etc. :-D

:party: Got a replacement today. The motors at Intex were on back order so they shipped a hole unit free of cost. Great service. I ended up opening the motor to find that the front bearing was damaged. Found some corrossion on the left front motor support screw so I have to check the salt level...

Mine is diferent. It gets louder by the hour until it sound like driving a car on rims at 60Mph in a police chase. It gets like this like after 6+ hours of use. Then It starts fine the next day because its cool again. Intex is sending me a new one, and I get to keep the bad one. I will open it...

I will do that. Thanks a lot. :)

The noise is really coming from the back of the motor. Like when a electric motor is about to die. Is not a crumble sound. I will check tomorrow anyway. I'm new to this. Thanks for the tip. :-D

The flow rate feels the same. As powerful as new. So I will have to disassemble the unit to get to the impeller right? From the basket through the motor?