Search results

Here they are

Hi Everyone. I have a Raypak heater that is not igniting when calling for heat. I can hear the spark, but no flame afterward. My best guess is the pilot orifice is dirty, or there is air stuck in the propane line. The worst part is the display is wrecked so I can't see if there are any error...

Hi Everyone! What would cause high filter pressure on a brand new FNS60? On startup the pressure shot up to 30psi and remained the same after adding the required amount of DE. EQUIPMENT SETUP Pump - Pentair Whisperflo 1.5hp Filter - Pentair FNS60 In-line chlorinator Heater - Mastertemp 250

DE filter

Hi Everyone. I’m having trouble with a Jandy JXI heater that sits about 3’ above pool level. When the heater calls for heat it fires up no problem but then is quickly followed by what sounds like a restriction in flow then the heater turning off and the “Check water flow” code. I’ve called the...

Update. I tested the gas pressure and Static pressure 11.11 in WC and when the gas valve opens it’s fluctuates between 10.11-10.25 in WC. So I don’t suspect this to be the problem. I’ve been monitoring the heater for the past 30min and it hasn’t shut off once. Which is odd. I will be...

Yes, I’ve tested the gas pressure before. 10in wc static and a slight drop when the valve opened. I cannot remember exactly how much. I will need to test again. Can you remind me how much of a drop indicates gas pressure to be the problem? And thank you for the Flame Sensing thread! Good read.

I have a JXI 260P that fires up great but shuts down after a minute or so. Before shutting off and starting its cycle over again it makes a weird noise that appears to be coming off the header. Just recently there was a short in the sub panel, so I had to swap the PIB and transformer. After...

New member here. My Mastertemp 400 has no power when I hit the buttons on the pad. I checked the voltage, and I have 240 coming in (red pin 240 connected). I was hoping someone could explain how I could check the voltage on the transformer and circuit board, so I can determine what needs to...