Search results

Thanks for all the replies. I am calling a competent professional to fix it as I am in over my head. IO error last go around but the ignitor is red hot.

Thanks for the reply. All offices are open. So maybe the gas valve? The gas smell is fient.

Edit to add the glow plug glows. No ignitor. Glow plug works fine.

My heater quite working suddenly. The heater did get some saltwater from Sally. I replaced the control board and the gas regulator upstream and all was good. Now the heater will do clicks and fan starts. The fan runs for 20 seconds then stops, then runs again and repeats. I jumped both...

My HVAC replaced the pool heater main board and I now have a display board on order. I am chalking it up to salt water from Sally.

As a follow up I replaced the main board with no success then the display board. All seems good now. Both boards were aftermarket products.

39.

0.

0 and 0. I just ordered a new board. I figure salt water in it didn't help things. Cheaper than the heater board I ordered.

No idea.

Temp 66 V 31.9 Amp 0 Output 53 IS 0 PC AL 1 Revision r1.59 Cell t-9 Serial # is think 3E2028-7036. Salt is 3900 measured with AquaChek strip.

To add, when first turned it will say generating then check salt comes on. No amps showing.

I have not read anything other than 0 salt reading. I added too much salt as I was getting a low salt light. I tested and salt was at 4030 PPM. In the dilution process now. The unit has generated Cl since I bought the house 3 months ago. The unit was installed 12/17. I replaced the cell and...

It is dissolving with no discoloration. Thanks to all for the replies. I used the Laglier saturation index and compensated for balance drift. Vinyl with Hayward generator.

I poured CC straight in and some caked in the deep end. I realize now I should have mixed it. Will it eventually dissipate? Thanks!