Search results

I ended up pulling the trigger on a SWG. I’m not familiar with IntelliPH, but I’ll definitely look into that.

Anyone familiar with this? https://pool-technologie.com/en/just-dosing_en/ It doesn’t list any US dealers, but I‘d be interested in seeing what the cost would be.

No drop on my overnight chlorine loss. The water is clear my CC is <.5. I started adding CYA back in today, and will check in a couple days to see where I'm at.. Thanks for the advice. Love this site!

Thank you very much for the help!! I'll shoot for 20ppm and measure a few days later.

Okay. I took it up to 10ppm, mixed for 30 mins and FC stayed the same. Should I start adding CYA?

Thanks for the replies. So if FC only drops 4PPM overnight with the cover on, would Ammonia be present? Or would Ammonia take FC down to zero?

I checked my CYA at closing in early October and it was sitting about 45-50. I SLAM'd for a couple days, winterized, and closed the cover. This year has been cold and rainy, so the pool hasn't been opened since October. I opened it on Saturday and it looked pretty bad. Lots of earthworms and...

I'm not that knowledgeable on the Stenner pumps. I only chose the pump I have based upon availability and low cost. I bet any of the Stenner Econ series 120v pumps would work for you.

At a little over a week of dialing this in, my FC is holding steady at about 3.5ppm. The pump runs for 45 minutes each night. I did notice that on the output connector there was a drip of chlorine after the pump ran one night. I suspect the home depot fitting isn't PVC and is leaking slightly. I...

I picked up a 20 gallon plastic barrel from amazon for about 40 bucks shipped. Aside from smelling like cherry soda, it works great.

Nice job! You might want to change out the clear tubing for black poly tubing so the UV doesn't degrade the chlorine. Also, a container that is UV protected would be recommended for the same reasons.

Cool! - thank you for the guidance.

My CYA is about 40. I have the pump, barrel, and wifi switch in my garage. The poly tube runs through the wall along the bottom of my house siding and about 10 feet to the pool equipment.

I ran the power today and mounted the button switch to the wall. I’m super happy to have this in place.

Thanks for the service manual. This will definitely help me keep this running.

So, I'm tired of adding LC to the pool every couple of days. At the beginning of the season my CYA levels were at zero, so adding a puck or two wasn't too big a deal. I have a Trichlor dispenser that I would keep on a low setting with a couple of pucks. It seemed to baseline the pool at about...

Thanks!!

I've performed my SLAM and passed the overnight FC test, CC is holding below .5, the water is clear. I ran through all the tests again this morning to see where I am: FC - 6.0 CC - <.5 Ph - 7.2 CH - 400 CYA - ~30 TA - 210 Temp - 79* Should I be concerned about TA? I'm told that the water...

I second the Tristar VS.

I don’t think so. The two others are identical.

With my new pump, I'm showing that I have plenty of flow; but the water on the surface isn't moving as much as I would expect. Based on the placement of the jets, I can tell the setup is intended to direct flow into the skimmer. Looking closer at one of my outlets, it looks like it may have had...

Started the SLAM yesterday evening. I added the suggested chlorine amounts from poolmath and checked about 30 minutes later. My FC measured at 18. CC measured at 1.5. Measured again this AM before the sun came up. FC is at 15 and CC is at 1.0. I have to say the TF 100 leaves little room for...

So I'd be okay to get my CYA up and SLAM?