Search results

  1. S

    Jandy epump help troubleshooting and testing

    Somehow got it to work. Messed with the PDA again and it was on the wrong time. That was all I changed and the pump came on. Probably a coincidence but I ain't complaining
  2. S

    Jandy epump help troubleshooting and testing

    I am in Prosper. Did you guys ever figure this out? My pump is doing the exact same thing. Just didn't come on today. I have 240V at the pump and 9.8V between the red and green. The Jandy PDA says pump offline. I checked to make sure the impeller spins freely. My PDA will control all the...
  3. S

    Polaris 9550 trouble

    My Polaris 9550 had a bad motor block and I got a new one. I also have a brand new control unit. The only thing that hasn't been replaced is the cable. It works now except once it climbs up to the waterline, it shows an Error 10 and shuts down. I've pulled on the cable while it is running and...
  4. S

    Planning a new pool and backyard build, Phoenix, AZ

    Looks awesome. If you plan on doing the Italian Cypress in the background of the rendering (which I think look great) make sure you get healthy ones. I put 5 just like the rendering behind my Baja shelf and they were all great for about 2 years. The had a gentle slope in height from the...
  5. S

    9300xi problems and solutions

    I have an older model 9300xi. I recently had to replace the motor block. It looked like water got into it and corroded the circuit board. Ordered a new motor block for $398. I installed it and after 2 days, the lights on the controller started blinking and the cleaner didn't move. Those...
  6. S

    DFW Builders

    My brother in law used Klapprodt. Very happy with them and they have taken care of him on some warranty items (acid washing to get better finish, skimmer leak, etc.). We are in Prosper, on the other side of the Metroplex, and used Claffey. They are based in Southlake. I can't recommend them...
  7. S

    DFW Texas Pool & Spa Build (Round 2)

    We have had our Claffey built pool since 2011. Nothing but praise for them. Great to deal with and do what they say. We have two Jandy Watercolors LED lights in the pool and one in the spa. They are adequate but I'd add more of the newer nicheless style if I could do it over again. Other...
  8. S

    Spa or no spa? If yes, raised or flush?

    I definitely recommend a spa and a raised one at that. The raised spa keeps it cleaner - anything blowing around on the deck like leaves, etc. don't generally make it into the spa where if it was pool level, it would blow right in. Also, when cleaning the deck with a backpack or hand held...
  9. S

    Filling your pool--set an alarm?

    Not exactly the same but similar and a funny story. At my parent's house growing up, we didn't have an autofill on our pool. We had a PVC fill line built in but it was manual operation. Every time my dad would turn on the fill, he would take one shoe off and leave it out by the pool. That...
  10. S

    Contract signed; thinking about audio pre-wiring

    I'd have them pre- wire to some flower beds that you have in the pool design, around the pool. Bring the wires back to the place where you would like your receiver to go. It doesn't have to be in an outside cabinet, etc. Get a receiver with Airplay and App control and it can be controlled...
  11. S

    Should I upgrade to Jandy watercolor LED from incandescent?

    That seems about right. How many lights is that upgrade price for? I put LEDs in when I built our pool and I love them. I have them turn on every night for a couple hours via automation for ambiance. It is nice to have them change colors. An LED won't be as bright as an incandescent so if...
  12. S

    Music outside

    I used to have two outdoor speakers under our patio and two pool speakers connected to zone 2 on my Onkyo 7.2 receiver inside the house. They each had their own separate in wall volume control that impedance matched so I could run two speakers off each channel for 4 speakers total. It worked...
  13. S

    New Build in Corinth TX

    I will definitely concur that Claffey will make you happy. They are great to deal with, even 4 years after we built the pool with them. I think that the after picture looks great. Great looking pool
  14. S

    Looking for a cost effective music system for covered patio.

    Also, in my experience it is better to have a larger system playing at less than its max volume vs. having a smaller system turned all the way up to try to get the appropriate volume from it. I initially undersized my system and regretted it. Not that I needed it louder, bit I WANTED it...
  15. S

    Looking for a cost effective music system for covered patio.

    I used to have two outdoor speakers under our patio and two pool speakers connected to zone 2 on my Onkyo 7.2 receiver inside the house. They each had their own separate in wall volume control that impedance matched so I could run two speakers off each channel for 4 speakers total. It worked...
  16. S

    New Pool Build in Frisco/Mckinney

    Foley is good. My brother built with them. We are friends with the family. Give them a shout and they will try to work with you, if you are getting a quote in the area. They will do their best to make you happy.
  17. S

    Does this sound off to you?

    We are in North Texas/Dallas. Prosper, Texas. We did have the crushed rock put in prior to gunite. We built with Claffey Pools and they touted this as an included upgrade to account for soil movement that you would pay for with other builders. I'm sure we paid for it, just not in a separate...
  18. S

    East Dallas New Construction Help

    I second Claffey. Had ours built in 2011. A bit smaller than yours at 780 perimeter but it is a diving pool. Much less expensive and got all the bells and whistles. On top of that, they are still honoring some warranty items 4 years later for us. Great customer service.
  19. S

    1963 pool resurection

    On the landscape lighting, I used the transformers from Lowe's (Portfolio brand) that have the photo sensor. I love that you can have them turn on at dusk and then stay on for any number of hours you specify. I have mine set to turn on at dusk and then off 6 hours later. Saves them from being...
  20. S

    Neat new product I found at the pool store

    Fixed Signature
  21. S

    Neat new product I found at the pool store

    Pigeon. It isn't an above ground pool. I just don't know how to change my signature. I don't know where that signature line came from. Mine is a gunite in ground, around 40K gallons and I'm in Texas. I need to figure out how to fix that since it is confusing as heck. Thanks for the kudos on...
  22. image.jpg

    image.jpg

  23. S

    Neat new product I found at the pool store

    They don't sit flush with the surface but they are not very high at all. You can step on them and they are wide and flat and are only 1-2mm up from the surface. Fine for my application. I like 'em.
  24. S

    Neat new product I found at the pool store

    http://www.amazon.com/FLOLight-Wireless-Swimming-Pool-Light/dp/B00JJZFLLA I have been kicking myself for 3 years since installing our pool that I didn't put lighted bubblers on our tanning ledge. I even looked in to getting them replaced but with the concrete work, etc. it just didn't make any...
  25. S

    New pool/spa build in North Texas Updated: PICS

    Tree Land is the absolute best. We bought all our trees from them and could not be happier. The best part is you can ride around in a golf cart and tag all the trees you want. Adds up fast though!
  26. S

    Another pool north of Dallas

    I second the vote for Tree Land in Celina. The owner is Bob and his son is Derek. Great guys and they have good healthy stock and great prices and volume discounts. We put in an entire berm with their stuff two years ago and it survived the drought, grasshopper infestation last year and...
  27. S

    Osage Hills Pool Build

    Looks great. On the umbrellas, if you open them only about 3/4 of the way, they will be less likely to blow away in the wind. The wind fills them up on one side but since they aren't tight all over, they don't fly away as easily.
  28. S

    Added borates - passed the ultimate test

    I added borates (20 Mule Team) and MA this Friday to my ~35K gallon gunite pool. I pulled the Nature2 cartridge and added all the stuff per the directions here. Swam with my family for about 4 hours yesterday. Both my 10 year old daughter and my wife said the water smelled much better (like...
  29. S

    Tiling above the skimmer?

    On my pool, they used an aluminum plate for the same purpose. Sturdy and no issues with cracking, etc. I only know what it is because I saw them install it. Other than that, I've never noticed what is there even swimming in the pool. Shouldn't be an issue for you if it doesn't match.