Search results

  1. M

    2 1/2 week into SLAM

    I just test the CC and it registered 0. However, my R-0003 expired in 6/19.
  2. M

    2 1/2 week into SLAM

    I had forgotten what CC stands for. I typically add chlorine once a day in the mornings to bring it up to 16. It has usually dropped from 16 to 11 by the next morning. The days that I have checked it at night, then again the next morning, it has gone from 16 to 14 and I would give it a shot...
  3. M

    2 1/2 week into SLAM

    Also, with the info I gave above, is there any possibility that this pool will clear by Wednesday. Water is cheap here, chlorine is not.
  4. M

    2 1/2 week into SLAM

    Thanks for the responses FC - 20 (because I aggravated before I posted this thread and dumped 1/2 gal in the pool to see if it jump. It went from 14 to 20) CC - unknown Ph - 7.2 TA - 50 CYA - the black dot disappears between the 20 and 30 mark so at least 20. Last week I pulled the head off...
  5. 1C96479E-C1F6-4696-B7D9-2473E67A13D1.jpeg

    1C96479E-C1F6-4696-B7D9-2473E67A13D1.jpeg

  6. M

    2 1/2 week into SLAM

    ... and I’m about ready to give up. 21’ above ground pool 10,400 gallons Sand filter Ph 7.2 CYA at least 20 I left my pool unattended over winter and of course it got really bad with algae. I drained the pool but left about a foot of nasty water in it. I’ve been slamming now for 2 1/2...
  7. M

    This is how I feel with all these big pools around here lol

    I think the water looks a little cloudy. You need to buy a TF100 test kit and post a complete set of test results.
  8. M

    How do you add CYA to an above ground pool?

    It could take about a week for the CYA to completely dissolve to enable me to get an accurate measurement with the CYA test. I also tried the bucket method first and it did not appear that my CYA was increasing as it should. I then used the sock method. I did all this over the course of one...
  9. M

    new plumbing for existing AG 20x40

    Think of it this way, if you have any joint, valve, piece of equipment, that may need to be tightened up due to a leak or need to be replaced in the future, you won’t be able to if it is glued into your run of PVC pipe. You would have to cut that part out and redo the plumbing. Unions enable...
  10. M

    new plumbing for existing AG 20x40

    And, don’t forget to put Unions where you need them like I just did. I plumbed my system then realized I couldn’t replace my pump if needed. I ordered some 1 1/2 unions from Poolzoom and installing them is my project for this morning.
  11. M

    Does anyone have experience with an AGP from MGK Pools

    My experience with MGK was not good. I ordered a Pool from them then later discovered that the Pool will be shipped and arrive on an 18 wheeler. If your home is in a location where an 18 wheeler can’t turn around then they won’t drop it off at your home. My driveway is about 200 yds long and...
  12. M

    Deck ladder advice

    Yesterday I installed an old 4x4 deck on my pool with steps leading to ground level. The deck and steps were left overs that I pulled off my house when I installed a large screened in porch/deck/ and new steps to the house. For the Pool ladder, I just used the same standard plastic ladder that...