Search results

I had an issue with my old 1081 CT1102 1 HP motor. I wasn't able to fix it, and ultimately ended up replacing it with a new UCT1102, which is just the more eco-friendly version of the one I had. I installed the new pump and turned it on. I kept an eye on it for about ten minutes and everything...

The pump was humming and shutting off, so I went to remove the capacitor to test it, and as I pulled off the leads, one of them just popped off (see the included pic). I assume I'll need to sodder it back on, but I don't own any soddering equipment, and have never used any before, so I wanted to...

Hey... so the timer on my pump bit the dust this past week after only having been installed for a few months. It was a relatively cheap digital timer from Home Depot that was 120V, 240V, 277V selectable, and when I went to leave a review for it it had already been discontinued, haha. So I...

So I replaced my old motor with a used one that a member here was getting rid of (Super II 1.5 HP). It's an older unit that had been sitting out for at least a few months. A touch of WD40 got it spinning fine and the gasket and o-rings all looked serviceable. I have it installed now, but when I...

Hey, I have an issue where my PVC piping come out of the ground is too close to a wall to be able to remove/install a new pump (Hayward Super II). I was hoping for some advice on cutting into and adding to the existing pipe to give myself a little more play. Obviously flexible 2" PVC piping...

I have a Hayward Super II that started leaking. When trying to remove the motor to replace the seal and o-rings, four of the six bolts must have been overtightened, because the inserts are just spinning. I can pry the case off about an inch before it hits the back wall, enough to see it in...