Search results

Unfortunately not. I've ran out of solution so I'll have to get more before another attempt

So tried 1 point calibration. 1. Entered Cal and held menu to clear. 2. Entered cal again and controller asks for 7.01 3. Place probe in solution 4. Say recognized and then wait before going back to main display. Heres strange thing. 1. While still in 7.01 cal and before wait appeared the...

I'll try that today, Cheers

Yes, although ir says save and seems to exit cal mode automatically as it goes back to main display after 1 ior 2 seca

Double point calibratio. 4.01 and 7.01. Controller recognizes both and says save on display. I then placed into pipe, probe should sitting at least half into pipe. Display never goes above 4.03. Tried reset controller. Removed from pipe and placed into new 7.01 sol assumimg that it should read...

New from manufacturer with cap with fluid to prevent drying out.

Saw some threads relating to the Hanna BL100 PH controller so hoping someone may have some isights into why I cannor get this working. it calibrates just fine but when in pool line always reads about 3.9/4. I have tried calibration and then immediatly dipping back into 7.01 sol but reads low...

Hey, Thanks to all how replied, I really appreciate everyone's time. To answer Dirk, the surface of the pebble is definitely got hairline cracks, how deep I can't tell but as couple of you have noted most likely water is running down those from above and the stone at that point is already...

So what does that mean as far as integrety is concerned. Best to leave it ? Thanks for the reply

Hi, I just did a partial drain of pebble tec pool,not quite half but i noticed that in one area the water was not drying as fast, leaving what looks like cracks. On closer inspection i def see what look like lines of very hairline crack. At least i can see that some of the small stones are...

Done :-)

Dirk, you are the man, I got wife to check it and sure enough it was turned off. I can only assume that they turned it off when replacing sprinkler and not back on !!! In the years I've had pool I've never had to think about it ! Thank you so much as this was obviously a worry, and not too...

ooooh, that second pic looks familiar. I def have one of those at the outdoor faucet, not too far away from equipment. I'm so excited I'm going to call wife and get her to check that hasn't been turned off for some reason, assuming that could be it. We do have gardeners who, about moth ago said...

Hi Dirk, thanks for reply. To answer last question first, it was definitely working fine as I did check it now and then by pushing down o the float and saw/heard water gush. Also, I removed the entire valve assembly by unscrewing it to leave just the open ended pipe sticking out into pot, so...

I have Hayward AquaConnect also and what you're experiencing is just how it works. It is by far the worst UI I have ever used, truly awful. If you connect directly using the IP address it a little more responsive but still pretty bad to use. Simple things like being able to quickly change light...

Hi, Thanks for the reply, most appreciated. I cannot find anything that remotely looks like it had anything to do with the autofill at the equipment end. I've also looked around and there's nothing. I've taken a few pics. The only thing that is unusual is a what looks like a small pipe inside...

Hi, I've searched forums/google but all that comes up for autofill are problems with the valve itself. I noticed that the pool water level was way lower than normal and it seems to happen over few days. Also the pump was laboring, going in spurts. We have solar nets but I have disabled that...