Search results

  1. Tommygarry1

    Replaced some tile

    Hi all. I replaced some tile in my pool and I'm wondering when I could raise the water level back up. I used a fast setting mortar that the manufacturer says could be used underwater and can be grouted within 2 hours and "traffic" in 4. Thanks for thoughts
  2. Tommygarry1

    Jandy Salt Cell 1400 Code 121

    Hi all, I had an old jandy cell with code 121. I ended up taking it off and cleaning it but it didn't work. So I bought a new one from an online supplier called pool supply unlimited. I just installed the new one. Initially, I had the same code again, 121. Then after about 5 minutes the code...
  3. Tommygarry1

    Pump Upgrade

    Hi all. I have 3 WFE 8, 2 HP Pentair pumps. They are old. They operate one water feature and 2 sets of jet returns. I have aqualink RS8. Original installation. If I purchased VS pumps, do I need to change anything with the Aqualink system? Also I found replacement motors online for good...
  4. Tommygarry1

    AquaPure 1400 General Fault

    Hi all: I have an Aquapure 1400 cell. I am getting general fault 121 which means clean or replace cell. I seem to experience this when I open and when I close -- typically when water temp is colder. Right now it is 54 degrees and in October when I close, it gets down to the mid-60s. Seems...
  5. Tommygarry1

    Tile Adhesive

    Hi TFP. What's a good time adhesive product. I have a few tile that fell off during winter and I want to reapply them. Thanks
  6. Tommygarry1

    Closing Pool - Gaps between edge and cover

    Hello community. I have a couple of spots where my pool cover butts up against my pool edge but there are slight gaps where leaves in debris can get in. Anyone have good recommendations or links to products that would fill this void? Thank you.
  7. Tommygarry1

    Emptying Pool Question over Winter to do reno work...

    Can you leave a plaster pool uncovered without water in it throughout the winter without it damaging the plaster? My plan is to replace the coping, tile and pool decking, along with reengineering plumbing, over the winter and I can't do that without leaving the pool empty. I did have a thought...
  8. Tommygarry1

    Adding Calcium

    Hi all. Anyone ever add Calcium and the test doesn't budge? I added 12 lbs of Calcium to my pool which according to pool math should raise it about 46. I did this at a 250 reading. I tested a few times after and it was 275 once only to read 250 again. I added another 12 lbs and it went up to 275...
  9. Tommygarry1

    About to SLAM

    Hi all, I'm about to slam my pool. I'm going to lower the pH to 7.2. do I really need to wait 24 hours before I add liquid bleach? Thanks.
  10. Tommygarry1

    How did this happen? Algea Explosion

    Hi everybody. I woke up to a green and cloudy pool this morning after flash flood type rain yesterday. I have been taking care of my pool for the past three summers and this has never happened. The last time this did happen was the first year I owned this house and I was not taking care of the...
  11. Tommygarry1

    Mustard or green algea

    Hi TFP community. I noticed some spots on my walls. Nothing obvious to the regular bystander, but I am very analytical with my pool. When I brush it, it comes right off. Later on, I notice that it comes back. From what I read, this could be a little mustard algea, although I also read that is...
  12. Tommygarry1

    LSI/CSI vs individual components

    Hey TFP community. I'm helping a buddy balance his pool. His numbers are as follows. PH 7.5 Ta 155 FC 5.5 TC 5.5 Salt 3500 CH 250 Water 70 degrees (he really needs to put his heater on!!) He has Taylor Test Kit. He has a 24,000 gallon concrete pool. I've become a bit of a analytical when it...
  13. Tommygarry1

    Cal Hypo CH dose?

    Hi TFP community. How much does 1lb Cal Hypo increase CH a 30k gallon pool? Thx
  14. Tommygarry1

    Calcium hardness products

    Hey TFP, community. Hardness plus, sold at Leslie's is expensive. But I'm always hesitant to use products in my water outside of what's in pool stores. If I were to use the calcium pellets that I use in the winter to melt ice in front of my house, is that okay in my pool? Thank you.
  15. Tommygarry1

    Issue with chlorine production

    Good morning TFP community. I am posting this question for a friend of mine who's having a lot of challenges with his Hayward 900, with a T cell Hayward 940. He keeps losing all of his chlorine throughout the day. He does get sun from set up to sundown. I explained to him that sometimes you have...
  16. Tommygarry1

    Pool Stain Question

    Hey trouble free pool community. I have this stubborn stain at the bottom of my pool. I slam my pool every open as I typically need to with the amount of algae I get. The pool is crystal clear and there are no stains anywhere with the exception of this one stain. I did a vitamin C test on it and...
  17. Tommygarry1

    DE getting into pool

    High TPF community. I do not have DE blowing through my returns. But I do notice in the morning that there is a little bit of DE on the ground where the wall meets the floor and it's coming out of the skimmers. I assume this is blowback when the pumps turn off some of it's getting back through...
  18. Tommygarry1

    Hayward DE Filter with slow leak around clamp

    Hi TPF community. I have a slow leak coming out of my DE filter. It won't go away. I've tried all of the troubleshooting steps -- re-seating it, lubing the o-ring, hitting the clamp with a rubber mallet, Retightening without overtightening, etc. Filter is only a couple of years old. Should I...
  19. Tommygarry1

    Winterizing a gunite pool with spillover spa

    Hi all...when you winterize a spill over gunite spa/pool, is it customary to leave water in the spa or is ok to leave it empty? Pic attached. I am in NYC area
  20. Tommygarry1

    Second Skimmer hole

    Hi all: I have 2 skimmers. Both have 2 holes. In one of them the 2nd hole is capped off from underneath. In the other one, the 2nd hole is capped off with a winterization plug. My question is — is that winterization plug glued in and that pipe goes to main drain? If so is the main drain...
  21. Tommygarry1

    What is this pipe for?

    Hi all. There is a half inch pvc pipe coming out of the ground near my pump station that is capped off. What is that for?
  22. Tommygarry1

    Aquapure Jandy Salt Sensor Issue

    Hi all, I was having an issue with my salt cell sensor giving me erroneous salt readings and eventually not detecting flow. After looking at troubleshooting guides I decided to purchase a new sensor. I installed it and it worked great for 10 days, reading the salt accurately and detecting flow...
  23. Tommygarry1

    Backwash Hose

    Hello forum. Can someone recommend a good backwash hose? I bought one from Leslie's but it is poor quality, twists and gets jammed even after rolling it out straight. Thanks