Search results

My spillover hot tub drains down to the same level every night which is just below the sandstone cap (between 2-3 inches) that makes up the spillover. I have had the same leak detection company out twice to diagnose the leak and they did apply some epoxy to a suspect area (receded mortar between...

I have intermittent bubbles rising from the jet opening shown in the picture. The bubbles are coming from the small clearance between the pebble tec surface and the gray jet housing. I tried to capture a photo as best I could of the bubbles. I should add that I also have intermittent bubbles...

Motor/Pump is starting to make a lot of noise so I’m sure the bearings need to be replaced. The motor is a Century B668. I’ve searched and searched and I’m not able to find part numbers for the bearings. Does anyone know which bearings this motor uses? And is it advisable to replace bearings or...

Not sure if I’m posting this in the correct section but I have a white flaky material that is showing up in my pool and most notably in my hot tub. The flakes will crumble and have the same consistency as salt or sand when you rub it between your fingers. Per my system my salt level is at 3050...

My IC 40 is displaying a low salt reading (2600 ppm) via the cell red light and the system reading. I’ve tested the water with the K-1776 and verified it to be 3400 ppm. Testing for chlorine it would seem that the cell is not producing at the moment. The cell is roughly 2.5 years old and I...

The Pentair owners manual states that continuous use at water temps below 68 will cause damage due to condensation. Water temp is currently 63 and I’m wondering if there is truly any harm in heating the tub for the kids for the day? Any thoughts?

Trying to diagnose an on going issue with a zero salt level reading on Screenlogic. My pool temp is currently 51 degrees so my cell only has a cold water indicator. I recently replaced the flow switch on my IC40 after speaking to Pentair tech support about the zero salt reading when the water...

A few days ago I noticed that my screenlogic app was reflecting a zero salt level however I was not getting a low salt indicator on my generator itself. After searching posts on here I came to the conclusion that my flow switch is probably to blame but didn’t feel that it was critical to fix...