My T-15 cell is nearing it's end of life, and to maximize it's potential, I tried switching the cell type from T-15 to T-9 on my OmniLogic controller. When I did this, the PPM increased by about 400, however on the Aquarite diagnostic display it's still showing T-15. I'm not sure if I should attempt to change the cell type on the Aquarite itself, I'm a little worried that I'll somehow get it out of remote mode if I try to do that. FWIW, the Aquarite does show the output that I have set in my OmniLogic.
Omnilogic and Hayward Aquarite
- Thread starter browerjs
- Start date
- Jul 21, 2013
- 65,165
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
Why isn't your cell connected directly to your OmniLogic panel?
Show me pictures of what you have.
Show me pictures of what you have.
- Jul 21, 2013
- 65,165
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
Hayward uses very confusing naming.
You have a OmniHub controller, not OmniLogic.
Change the cell type in the Aquarite panel.
You have a OmniHub controller, not OmniLogic.
Change the cell type in the Aquarite panel.
I changed it on the Aquarite and after 30 mins or so the PPM went up another 400.