I usually have trouble getting my Raypack 366A started after a long winter but this year I have encountered a problem I've never seen before. Usually it's the Pressure Switch is stuck, or I have air in the lines and eventually get ILO (Ignition lockout). Eventually it starts up. But not this year.
Hoping someone on the forum has seen my new issue and might know some troubleshooting tips for it. Basically, when I turn the unit on, I get the CFH, then SPK and after a couple of cycles of sparking, the flame icon indicates that the unit is heating. However, the unit has not actually fired up....
My propane tank level is below 20% and I'm wondering if that level is too low to get enough fuel pressure to the unit. But in that case, I would expect the controller to think that it actually fired up and thus start the flame icon.
Anyone ever see this behavior before?
Hoping someone on the forum has seen my new issue and might know some troubleshooting tips for it. Basically, when I turn the unit on, I get the CFH, then SPK and after a couple of cycles of sparking, the flame icon indicates that the unit is heating. However, the unit has not actually fired up....
My propane tank level is below 20% and I'm wondering if that level is too low to get enough fuel pressure to the unit. But in that case, I would expect the controller to think that it actually fired up and thus start the flame icon.
Anyone ever see this behavior before?