I've been discovering over the last week or so that my SWG keeps getting set to 0% output, as seen in the iAqualink web Status page. Has anyone else ever experienced this? I have the RS8 panel, iAqualink and TruClear SWG. I have not been able to find any rhyme or reason for this. I reset it, and later in the day I'll find it's back to 0%.
Jandy RS8 sets SWG to 0%?
- Thread starter WGpoolnewb
- Start date
- Jul 21, 2013
- 65,620
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
The local Jandy warranty vendor had a long wait time, so I decided to take a peek at the RS485 wiring at the controller. I did nothing more than remove and reinstall the wiring on the terminal block, and the issue has not returned. I did also try to contact Jandy directly for guidance, and that went absolutely nowhere.
Nevermind, it's back. Go figure it decided to happen again sometime during a 10 day cruise.
Last edited: