We have a Hayward system using an Omnilogic control panel. It used to seamlessly all work together, where I could set schedules and the pump and heater would come on when desired and switch between the spa and the pool without issue. Recently our (now former) pool maintenance person shut it all down to replace the filters and now the panel no longer controls the heater. The pool is supposed to heat from 8am to 2:30pm, and then switch to spa mode from 2:35pm to 6:30pm. The pump and automated valves do this without issue. The panel will say the heater is on and running, but the heater is actually not on.
To add to the confusion, the heater is operational but it comes on randomly (to any schedule) at 2:25pm and runs to 6:30pm. Also, the Omnilogic panel heater temp is set to 104, but the spa will only heat to 100, which is what is on the actually heater's display.
How can we "reconnect" the heater to the Omnilogic panel?
To add to the confusion, the heater is operational but it comes on randomly (to any schedule) at 2:25pm and runs to 6:30pm. Also, the Omnilogic panel heater temp is set to 104, but the spa will only heat to 100, which is what is on the actually heater's display.
How can we "reconnect" the heater to the Omnilogic panel?