New Tristar SP32950VSP pump installed. Just want to be sure I’m understanding Dip Switch settings correctly for communication with my ProLogic PL-PS-16. The Prologic will be controlling the 950. What should those setting be?
Dip Switch Settings for Hayward Tristar
- Thread starter 1sato
- Start date
I don't see any instructions for dip switches.
I don't think that it matters for this pump.
I would leave it as it came from the factory.
If it does not work, try setting all to OFF.
I would leave it as it came from the factory.
If it does not work, try setting all to OFF.
If the manual doesn't state a needed change for your system, then factory setting of all in the "off" position is correct.
Have you seen JamesW's post? Better to have the options and not need them than need them and not have them. Hayward has pretty much covered all the contingencies that may arise in a complicated pool installation.
Would like to hear from Tristar owners regarding their dip switch settings and configs.
The post where you got the picture is 3 years old and the pump is a different model and the automation is also a different model.
Your pump uses the interface to set the address.
Did you install the pump or did you have it professionally installed?
Is it working correctly?
Can you show a picture of your wiring compartment?
Shellie posted this 04 July 2019 - Last edited 06 July 2019
Communication Issue Between TriStar VS900 Pump and OmniLogic
www.inyopools.com
Your pump uses the interface to set the address.
Did you install the pump or did you have it professionally installed?
Is it working correctly?
Can you show a picture of your wiring compartment?
Shellie posted this 04 July 2019 - Last edited 06 July 2019
Communication Issue Between TriStar VS900 Pump and OmniLogic
Communication Issue Between TriStar VS900 Pump and OmniLogic
We have recently upgraded from an AquaRite pool control system to the more robust OmniLogic. For the most part, things have gone smoothly. The only real problem we are having is that the Omnilogic doesn’t seem to want to communicate with the pump. The pump model is a Hayward TriStar...
www.inyopools.com
Yes, works. Model is SP 32950VSP installed by Florida Licensed Professional Pool installer who said the setting should be 1 on and 2 - 5 off.The post where you got the picture is 3 years old and the pump is a different model and the automation is also a different model.
Your pump uses the interface to set the address.
Did you install the pump or did you have it professionally installed?
Is it working correctly?
Can you show a picture of your wiring compartment?
Shellie posted this 04 July 2019 - Last edited 06 July 2019
Communication Issue Between TriStar VS900 Pump and OmniLogic
Communication Issue Between TriStar VS900 Pump and OmniLogic
We have recently upgraded from an AquaRite pool control system to the more robust OmniLogic. For the most part, things have gone smoothly. The only real problem we are having is that the Omnilogic doesn’t seem to want to communicate with the pump. The pump model is a Hayward TriStar...
Attachments
Last edited:
As far as I know, it does not make any difference.
Maybe contact Hayward to be sure.
Maybe contact Hayward to be sure.
Sent in a tech request to Hayward few days ago but no response. Am reaching out to learn other owner's experiences.
