Before I consider installing a SWG, few qualifying questions plz

Jump to latest Follow Reply
OK, so I get the Hayward AquaRite T-cell 15 for 40K pool, a flow switch and 2 2" unions.

Once I achieve 3000PPM salt in pool, fire-up the T-cell. Cell should be placed after the heater and close to the pool/spa return pipes. What is "normal" level of FC production[4 or 5 FC target] right out of the T-Cell? Can the T-cell be placed b4 the heater and or filter?

Flow switch measures the FC Output and where is the most optimal placement? One all is installed, then go to panel to set-up Salt cell to specified levels of output and low & hi threshold settings...

Am I missing anything ?

Thank you
 
just read 11-12...got it...flow switch needs 12" pipe or the body of T-cell before the flow switcvh to insure it can measure full water flow.

Has to be installed after heater and filter* and before returns to spa & pool...I'm running tight there so I might be improvising some vertical installs. Should have intuitively knew that it couldn't be installed b4 filter bc any debris getting stuck would not be good.

Will do a drawings and materials list...once verified, order is going to hit the i-net..

Thank you Allen from the Garden State
 
Last edited:
Was doing some searches on TFP w new SWG installs and read that a SWG does not product CL when temp is 60 degrees or less. In Tx, we have times where 60 degree temps and getting lower in the future is optimal SPA and Swedish Cold Plunges...what do you do for CL when it's colder ?
 
You must log in or register to reply here.
Thread Status
Hello , This thread has been inactive for over 60 days. New postings here are unlikely to be seen or responded to by other members. For better visibility, consider Starting A New Thread.
Top Bottom
Back
Jump to latest Follow Reply