My indoor panel is giving me problems. I tried to turn on pool pumps, lights up green and then turns off a few seconds later. Tried rebooting everything. Any ideas?
Problems with indoor panel for IntelliCenter
- Thread starter 21hamptonbays
- Start date
- Jul 21, 2013
- 65,761
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
What are your Backlight settings for the panel?
Is the pool responding to the changes you make on the Indoor Panel?
Is the pool responding to the changes you make on the Indoor Panel?
Panel is non responsive to changes. For example, I’ll change the temp from 80 to 82 and then a few seconds later it switches back to 80.
Also noticed light in top right corner is green but blinks yellow.
- Jul 21, 2013
- 65,761
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
I would check the wiring connections in the ICP and at the outdoor cabinet.
Before you touch the RS-485 wiring you should power down the IntelliCenter.
Sometimes the cable to the ICP goes bad or a critter chews in it. I don't knwo the path your wire takes from your IC cabinet to your ICP.
Before you touch the RS-485 wiring you should power down the IntelliCenter.
Sometimes the cable to the ICP goes bad or a critter chews in it. I don't knwo the path your wire takes from your IC cabinet to your ICP.
- Jul 21, 2013
- 65,761
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
Dunno. Pentair manuals don't say.
You can call Pentair Support and ask them.
If you learn anything please share.
