Hello,
Long story short, I am having an issue reconnecting my Easytouch Wireless Remote back to the Easytouch 8 panel. Looking for some help or guidance. I have tried the menu -> settings -> "Wireless Address" routine with no luck.
My main control panel came as Easytouch 8 chassis, but it came with a Easytouch 4 main circuit board. (It also has everything for SCG, but the actual cell). Working with a local mom and pop shop, they set me up with a new main circuit board that was an Easytouch 8. They actually gave me the main board for free due to all the issues with my Pentair Mastertemp. I wanted the upgrade as I was using all of the relay outputs. The upgraded board allows me to add an air blower to my spa.
I installed the new board and everything for the main pool/spa is working fine (pumps, valves, schedules, etc.) However, I cannot get the wireless remote to connect again. As said above, I tried the method through the menu, in settings "Wireless Address". The wireless remote just times out on "searching". My only thought, is the new main board is running on a new firmware that the RF transmitter is not compatible with (same with the wireless remote). The new main panel is on firmware VOC: 2.160 and the remote is on VOC: 2.130.
I have double check the RF transmitter is getting power and the 485 com link lights are blinking (not sure if the blinking indicates something).
Any other thoughts or suggestions. At this point, if it purchasing parts I will probably upgrade to the Screenlogic setup.
Thanks,
Long story short, I am having an issue reconnecting my Easytouch Wireless Remote back to the Easytouch 8 panel. Looking for some help or guidance. I have tried the menu -> settings -> "Wireless Address" routine with no luck.
My main control panel came as Easytouch 8 chassis, but it came with a Easytouch 4 main circuit board. (It also has everything for SCG, but the actual cell). Working with a local mom and pop shop, they set me up with a new main circuit board that was an Easytouch 8. They actually gave me the main board for free due to all the issues with my Pentair Mastertemp. I wanted the upgrade as I was using all of the relay outputs. The upgraded board allows me to add an air blower to my spa.
I installed the new board and everything for the main pool/spa is working fine (pumps, valves, schedules, etc.) However, I cannot get the wireless remote to connect again. As said above, I tried the method through the menu, in settings "Wireless Address". The wireless remote just times out on "searching". My only thought, is the new main board is running on a new firmware that the RF transmitter is not compatible with (same with the wireless remote). The new main panel is on firmware VOC: 2.160 and the remote is on VOC: 2.130.
I have double check the RF transmitter is getting power and the 485 com link lights are blinking (not sure if the blinking indicates something).
Any other thoughts or suggestions. At this point, if it purchasing parts I will probably upgrade to the Screenlogic setup.
Thanks,