New Member / Owner

Jump to latest Follow Reply
Doing a test found here to see if I can verify my pool volume.

A Chemical Way of Calculating Pool Volume

There is a way to use pool water chemistry to calculate pool water volume without using the traditional geometric calculations. The geometric formulas are fine for pools that are traditionally shaped. However, when pools do not fall into these convenient shapes, a chemical method can be used...
www.troublefreepool.com www.troublefreepool.com

Tested 250 ml and my TA is 86. Added 5lbs of baking soda. Now to wait 3 hours and test again!
 
Close enough to 3 hours. Measured TA at 104. So 5 lbs added 18 TA. Formula in other thread says 19833 gallons. So - 20k is pretty much correct. :)
 

Enjoying this content?

Support TFP with a donation.

Give Support
The new housing / lever section is $99.99 at IYO and the supporter benefit is $25 off...a $100 order. Need to get a tootsie roll with the part or something
 
Good job! I went on there thinking............."A washer can't cost that much" and was got a BIG surprised! Just a plain washer was $4.35!!! Well it did have Pentair's name on it so....:roll: At least the o-ring lube can be used!
 
The pressure on the jets keeps going down and some air in the pump basket. Hoping the leak in the MPV is causing that and not something else....
 

Enjoying this content?

Support TFP with a donation.

Give Support
You must log in or register to reply here.
Thread Status
Hello , This thread has been inactive for over 60 days. New postings here are unlikely to be seen or responded to by other members. For better visibility, consider Starting A New Thread.
Top Bottom
Back
Jump to latest Follow Reply