Help with Screenlogic Spa Pump Speed?

Hi guys have a question, I have my spa flow rate setting for 3400 RPM with my Intelliflo Pump in Screenlogic. Today, i turned on my spa and under the screenlogic Power Usage (Watts) and RPM it's showing 1420 Watts and 2800 RPM only. In the settings, my SPA Speed is showing 3400RPM, any ideas on what's going on?
Any help would be greatly appreciated.
 
David,

Can you post a screen capture of the flow rate page like the one below???

dbtgallery.php


Thanks,

Jim R.
 
David,

A puzzle???

Was it working before and suddenly quit, or did you reprogram it and then it quit?

Is the screen shot from your PC or Phone? If from your phone, I'd try setting it via your PC and see if it works then.

What did you, or do you, have that should be running at 2800 RPM?

Sorry, but was hoping it was something simple like it was stuck running something else...

I don't see anything obvious.

Jim R.
 
David,

Good catch.... I'm not sure I would have ever thought of that..

My guess is that about 85% of all EasyTouch 'Failures' are related to programming issue, or not understanding how the ET works, and only 15% have to do with an actual hardware failure.

It is also almost always related to the last change made.

Thanks for the feedback, as it may help other with the same issue.

Jim R.
 
Thread Status
Hello , This thread has been inactive for over 60 days. New postings here are unlikely to be seen or responded to by other members. For better visibility, consider Starting A New Thread.