Recent content by WshnIwslofn

So no one has a manual. Ok, how about my new problems. Light button and the light are blinking on and off, cannot turn on the high speed on the pump and the temp up button works but not the down button. The pump continues to run on low speed and it does heat. Does this sound like the control...

Hi Have a Down East hottub, either 2001 or 2002. Was playing with the panel the other evening and it popped up with F1 thru F12. I didn't know what this was and now the tub is running constantly and I cannot figure out how to get back to the F's which I now know is for pump duration. This was a...

I found a lingere bag in my laundry room (to put women's unmentionables in and throw in the washer). I throw my stabilizer into it, tie it off with a rubberband and then massage the bag in the water until the stuff has dissolved. I tested my water after 3 days and bingo...had CYA.

Hey everyone, You guys and gals do such a good job on this forum that I am becoming pretty much self-suffient in the pool area! Thanks. Now we are working on the hot tub! Last fall pulled out the air blower and got this off the unit. Air Pump, 2.0 peak, 4.4 amp, 220V 60HZ, 104 CFM 100 in. of...

Waterbear or Duraleigh Waterbear or Duraleigh, You two seem to have the a lot of experience with this. Just trying to kick it back to the front. Thanks

Hey, thanks all of you who are answering my questions! You are all life and money savers! Replacing my inground vinyl liner and need to know the tips for the main drain. I put a gasket down, liner, gasket, flange and then the drain cover, correct? Do I need to glue or caulk any of it? The...

Thanks Dave. But can you elaborate on how you know this? Thanks Kay

Just got the old liner out and am in the process of measuring for a new vinyl liner. Am looking at the floor of the pool and at first I thought it was concrete when looking at the shallow end. There was lose sand all around the edge, though. Then after looking around more, and gouging around...

Thanks, Duraleigh I think we will attempt it. Just didn't want to get into a mess w/ advertising making something impossible, 'easy'! Also, they are selling 20 or 28/20 mil liners. What can you tell me about them? I am in Illinois with freezing in the winter. Thanks Kay

Hi, Need feedback on DIY replacement liner. Can we really do it, is it as easy as it sounds?? Inground, vinyl, 16x32, beaded, approx depth 3 ft to 9 ft. Thanks Kay

When I am fighting algea, do I have to adjust my PH when, according to the test kit it has risen(7.8-8.0) because of the high chlorine. Is this the 'false' reading I am getting or has it really risen? Can I just wait it out until my chlorine level drops back down? Also when you are fighting...

I have a leak!!! Here are the facts: 16x32, 3 to 9 ft vinyl IG 1-skimmer, 1 main drain, 2 returns I lose approximately 1 inch every 24 hours with no pump running I lose approximately 1/4 in. in a 24 hour period with pump running I do not lose the prime in my pump...

Thanks Dave. Yes it did go away after I filled the pool some. Seems that if the water gets too low the skimmer starts sucking a lot of air. Has to be about 2 inches above the skimmer bottom. Kay

I had to replace the whole top on my sand filter about a week ago and yesterday it started making a lot of suction sounds ,on filter, somewhere inside and around the backwash line and air relief valve. There is no way to see iwhat is happening out of the backwash line (PVC plumbed into the...

Thanks. Kay