Recent content by wrbeyer

Thank you for the quick reply. I expected your answer - thank you for confirmation. I do believe that detached structures are allowed one circuit without a subpanel, so I guess that is what I will limit myself to. And as I understand it I could use a multiwire circuit to get the two circuits I...

We have a Pentair Easy Touch 8 load center used for the typical pool stuff. There is plenty of capacity (60 amp breaker in main) and 4 open slots for breakers. We built a pool shed just in front of the load center (literally 6" away). I would like to run a circuit (possibly two if allowed per...

I had a cover installed last fall. The installer didn't do a great job drilling the holes. First off you can see the chipping. Second, many anchors are set lower than the surrounding concrete, as much as 3/8". Obviously the appearance is not great, but I am also concerned about water getting in...

I think you can see from this picture that whatever caused the stains seemed to run. I have tried a few gentle cleaners but I suspect that something like a stainless steel polish would work. Thanks!

I have the same deck jets. I can remove the caps, adjust the heads, etc. In the winter I remove the heads and plug them just like any other jet. Mine are not flush with concrete, we had ours put in stone on one side of our pool where nobody walks. Hope this helps.

Hello, new to this great forum. I have found answers to most of my questions, but can't seem to find anything on this one... I have stains that appear suspiciously like drops on my stainless steel ladder. They are above the waterline and I suspect we were just too careless when adding liquid...