Recent content by Ultratec03

Makes one want to go to the pool store and test their display pool. Thanks for the replies

I am hoping to start up the SWCG this weekend as I will finally have the electrical ready. Before adding salt to the pool yesterday I tested the water for salt using the Taylor K-1766 kit. Very simple test (10mL of water, one drop of R-0630, add one drop at a time R-0718 until milky brick...

- - - Updated - - - Pretty skies and clear water - - - Updated - - - Also started on this little deck to use to get in and out of the pool. Too hot to build a big deck now so this will have to do until it gets cooler and I decide on a more permanent solution for a big area for people to...

I can't figure out how to upload more pictures. Will update again when I figure out how.

Been busy working on the pool. Here are a few image updates. - - - Updated - - - Water started. Well water was dirty so I switched to community water after this image. - - - Updated - - - Filling over the span of a few days... kinda greenish...

Mats didn’t work out because of the slope in the deep spot. Having sand delivered today to make the base inside the pool.

- - - Updated - - -

The sprinkler was for a little bit of both. Made the packing easier too. I have the top rails on right now because there was quite a bit of wind yesterday and I didn't want it to blow away. I found this page about expandable liners, but they filled the liner and dropped it as it filled...

- - - Updated - - - Tried to upload the other pictures, but couldn't get them to load. I have the walls up and hope to install the liner this evening. Having trouble finding information on how to install the overlap expandable liner. Seems there aren't many DIY above grounds with deep ends...