Recent content by TommySalami

We have a Hayward H350FDN heater approximately 5 years old, no problems until this year. I've day it kept heating past at temperature then shut off and looked without power. Breaker was OK. It turned itself back on a week later so I turned it off and called for service. The tech said "these...

I can't replumb the whole thing. Those intakes connect to the jets and it's where the air bubbles come from, but it's so loud. If you plug a jet, water comes out the intake. And the intakes also serve to keep the spa from overflowing.

Hi, I've got a gunite pool with a spa that uses 4 intakes that run directly to the 4 jets to create the bubbles. The problem with this design is the noise. If I plug a hole no air enters that jet. I'm wondering if anyone came up with a solution that decreases the noise without affecting the...

Y'all. Thank you! I unscrewed the 3 way inlet and didn't find any gaskets... But when I tightened it back up... THERE ARE NO AIR BUBBLES COMING INTO MY POOL. the spa isn't gurgling. This has not happened since we opened it last year. Thank you all for the help!

I hear an air suction leak at the 3-Way. Going to try to seal it with sealant. It has a few patches on it. Will replace it if needed.

Thank you both! The simmer weir is almost constantly open, and due to the construction it’s tough to know the best solution without filling the pool to a very high level. Maybe that’s what is needed. I am filling the pool higher and I will test for leaks in those spots.

Hi all, When the pump has been running all day and I turn it off, air rushes into the pump basket and water blows back and knocks off the skimmer lid! I have a 15k in ground with a spa, using a Speck sand filter, Pentair pump, Hayward heater, and Intellichlor SWG. My maintenance crew replumbed...