Recent content by TimmyR

I’ll post details once I get more info. At this point it appears to be a viable option for my pool deck. We are waiting to see it installed on someone’s pool and hear what they say about it.

Thanks, that’s why I asked here. I was looking for any direct experience. We are doing all of the above while researching. The “more traditional” method as far as I can tell is to demo and replace the pool deck. That’s looking to be cost prohibitive at this point. Thanks for the input.

Obviously there are potential issues with any product like this. That’s why I was asking for any direct experience. We had the quote and consult this week and are going to go look at it installed at one of their customer’s pools. Quality and warranty look good and it appears to be easily...

Does anyone have any experience with QuartzCarpet? It’s a treatment to resurface pool decks. I have 24-year old exposed aggregate deck and plaster pool (second owner of house). I’m not sure we are ready to bite the cost of new deck and pool re-plaster. My local company says the plaster looks to...

Original pool company looked over pool for a renovation assessment. They do not recommend doing a full renovation at the time. While my deck is in rough shape, he thinks the plaster looks to be in very good shape. The recomendation for now is to talk to a floor epoxy / coating company to see...

It appears we are on borrowed time (per my local pool maintenance store who also built our pool). My deck is in rough shape. It's cement with medium-sized river rock as the aggregate (I think) and hard on the feet. The plaster is all stained, I suspect we have leak and the 5-valve in-floor...

Well, I managed to fix it. It turns out one the gear pin did not break, it just slid down so one of the cogs would not stay on. I'm back in business. I still feel like I'm on borrowed time and perhaps replacing it is a smart move, but it can now wait until the end of the season.

Thanks James. I've scoured the links for the gear assembly and as it's discontinued it's not available. The link is one of my two local pool retailers and I planned to call them tomorrow anyway. It looks like I'm stuck until I can get it looked at. I'm guessing its a full replacement.

Any updates here? I have the exact same piece of equipment on my pool and the gear assembly has completely failed. I"m thinking I may pull it out and run it without it if I can get it to reseal until I can get a new one.

Thanks. I read that it needs to be outside when I searched for this topic here. It’s in my pool shack which is away from the house and not sealed at all. I may have figured out what is causing it.

Hi! I added some MA to my pool today from an unopened 1-gallon jug. When I opened the jug I noticed the seal was not in the best shape and may have seen a drop or two on the cap threads. The jug had been stored in my garage. Later today, I’m smelling something in that vicinity. My wife says...

Thanks. I've obviously not noticed the cracks. I'll do some internet searching and figure it out.

My pool has had 3 border tiles fall off in the last 24 hours where the spa flows into the pool (which is how it runs normally unless we switch the valves to "Spa" and recirculate that water. I believe it is simply due to age. We have lived here 10-years and the pool has to be at least 20-years...

I vacuumed the pool and took FC up to 22 ppm (CYA 50 ppm) with SWG off. I had to add water to the pool again to keep skimmers high enough so I rechecked it and had to bump it back up this morning. The pool is in Service Mode and filtering. I plan to change the filters tomorrow and call it good...