Latest activity Postings Media About
-
-
swamprat69 replied to the thread Jandy LRZE Ignition Issue.In what order did you replace the ignition control and the gas valve? -
swamprat69 replied to the thread Jandy LRZE Ignition Issue.I think that this may be the manual for your heater...
-
swamprat69 replied to the thread Raypak Flame Rollout around pilot.Just saw the videos. The whole burner flame should look like the flame does at the far end of the burner (defined two tone blue flame)...
-
swamprat69 replied to the thread Raypak Flame Rollout around pilot.The yellow at the pilot is probably due to dirt rerstricting the pilot orifice and a new pilot assembly should correct that. For the...
-
swamprat69 replied to the thread Raypak Flame Rollout around pilot.Flame rollout is indicative of a blockage to the flow of combustion byproducts. What condition were the burners in when you cleaned...
-
swamprat69 replied to the thread Raypak Flame Rollout around pilot.It looks as if you have multiple areas of concern ( bottom right and midlevel front ). Aphoto of the entire front of the exposed heater...
-
swamprat69 replied to the thread Featured AO Error - Now what!.A lot of things seem to be "off" in what you are showing. The 3 pressure switches seem to have different WC setpoints ???? Which one was...
-
swamprat69 replied to the thread Featured AO Error - Now what!.Before opening up the combustion chamber to check for any blockages I would follow the AO troubleshooting guide in the heater manual on...
-
swamprat69 replied to the thread Featured AO Error - Now what!.Sorry to having been silent for a while but my brother has been visiting and "forced ?" me to play poker constantly for more than a...
-
swamprat69 replied to the thread Both return and suction side leak.Not sure about total length of the straight runs from the picture. depending on the length of the straight runs and the flexibility of...
-
swamprat69 replied to the thread Featured AO Error - Now what!.This should be the manual for your heater...
-
swamprat69 replied to the thread Heaters and flow.A higher flow rate would definitely increase the heat transfer coefficient, but the increase would not be proportional. The increase in...
-
swamprat69 replied to the thread Problem with heater.It is entirely possible that the problem is not with the gas valve, so I would first try to get a qualified technician to do a throrough...
-
swamprat69 replied to the thread Problem with heater.Both K and H in the 7th digit designate a slow opening gas valve, You could go with a competitors valve that crosses to your original...
-
swamprat69 replied to the thread Problem with heater.Your heater does not look like it has been cleaned and operation checked by a qualified technician in a while. This can effect its...
-
-
Loading…
-
Loading…
-
Loading…