Recent content by SirNoSplashing

Another question if you are able to help - when cementing the diverter valves in place, any concerns with PVC cement going into the valve area? Do people usually remove the guts of the valve during gluing? I highly doubt they did when plumbing my setup. Just wondered what was common practice...

Thank you for the replies and help. Also, I was editing my post while you were replying: Regarding that item, could it be a water bond instead of an anode? And if so, I assume I want to keep that in place?

Thanks so much for the input! You gave me confidence in my plan. I guess that is an anode and I never researched them until now. I read that it is traditionally placed between the filter and the heater, not sure how critical that is - mine is obviously before the filter. If I remove it, that...

I am looking to upgrade my 1hp single speed. I am thinking of jumping to the Calimar 3HP, which could be overkill but I have a lot of pipe length and elevation change so better be safe than sorry. Given the price, its a no-brainer. Yes, this pump might be Crud but I am ok taking the chance on...

I have been looking into this pump as well and found this thread. FWIW this was the response I received from Pool Supply Unlimited: "It is in transit and orders should be getting shipped out in the next 10days". I am on the fence about buying a cheap pump, but given how significant the...

Just got back from my trip. Water is clear and the level was at the top of the skimmer from rain but not horribly high. I am pumping down to a reasonable level now and running my robot. Quick check shows chlorine is super high, 10 ppm. pH is high, but one drop of acid demand brings the...

I don't have anyone, and I am the only one I know with a pool.... but I have a buddy who is smart enough I could trust him to stop over and take a quick peek. Things like cleaning the basket, checking the water level would be simple enough. chlorine just is what it is, nobody could help me...

I have no overflow method, presumably it would rise above the FG tub and onto the edge of the concrete. Which seems bad. With crazy storms you could get inches of rain at a time, or without them, evaporate. For now I will just pump it down such that we could afford another crazy storm... but...

I will start by saying I did some searches on vacation prep, I know its a well covered topic. We just got a lot of rain and the water level is just a couple of inches from the bottom of the 4" concrete decking around the pool. Over the skimmer. Highest its been. Typically I would pump this...

This is a somewhat obscure question. We built a poolhouse on a concrete slab with a vapor barrier underneath. Ohio weather with temperature fluctuations, and its an unconditioned space. We are exploring a waterproof vinyl click-lock tile (the solid core with less expansion/contraction due to...

Yes we have a 12" pipe out near the deep end, and yes finished off with a skimmer lid. The opening is barely large enough for a pump, but it fits. Since I have a high water table I always have spare sump pumps around. Before they poured the concrete I actually ran conduit and 1-1/2" PVC...

Thanks for this. They backfilled with small gravel all around and "massaged" it in as they went. They backfilled at the same rate they were filling with water so the two levels went up together. I believe I have a main drain? There are two suction ports near the bottom of the sidewall in the...

Appreciate your response. To be clear, I am not draining. I am basically asking under what circumstances do you need to pump around the pool. In other words, should I be concerned at all if my water table is 3' from the water level in the pool? 2', 1' ? At what point should people care...

Hello all, this is my first spring as a pool owner. We have a high water table every spring, my two sumps in the basement run non stop for around 3 months, then they are dry the remainder of the year. We have 100% sandy soil conditions for what its worth. Right now the water table is about...