Recent content by shaneymack

I have a Taylor 1766 (?) And yes I tested it yesterday and was at 3600

I cannot run too much under 2000rpm as I have to meet minimum requirements for heat pump.

Running pump 19 hours on 2500 rpm. Using Taylor k2006c

That sucks, had I known I would not have wasted money on a SWCG. Kind of useless if I have to constantly still add bleach which is ridiculously expensive. With tax it costs a little over 8$ per 5L and with my pool size it would take like 20 litres to get it into the 20-22 ppm .

Wow I didnt think it was safe to swim over 6-7 ppm fc!

I added around 2 litres of purox this am. Should I bring FC up to 6-7 ppm before party and after ?

Thanks, Jim, I appreciate the help. I added 2kg if CYA 3 days ago. I was at 60ppm yesterday. I read on here that I should wait 7 days to add again to be sure not to blow past my mark. I just bought 5 jugs of purox and added a little to be sure I'm at proper levels untill I get this sorted out...

Here is a pic of shallow end and deep end

Yesterday am I noticed my FC was a little low. I checked again around noon and still low. I put the SWCG on super chlorinate all day and still didn't go over 3ppm. I left it on 95% and this am it is still at 3ppm. I'm in vacation and it's been sun all day every day and we've been averaging 10...

Last test was this evening ( log is in my profile) FC 6.5, pump running 41% output.

Heat warning in effect. Insanely hot and humid and full sun all day. So basically there should be 0 FC loss over night therefore I should not have to run the pump overnight ? All FC is lost during the day and that is the only time we need to have SWG running ?

I get that. Why is my fc at 6.5 right now with the SWG at 45% then ?

Ok I did that and it says it needs to be at 57%. However this doesnt seem to make a lot of sense to me. Isn't that just going to put the FC through the roof during those hours and then it will slowly drift down the hours the pump is shut off ? Having a hard time wrapping my head around this. My...