Recent content by Scrawner

Update: Contacted Hayward support, and they were very quick to respond and investigate. After sending some logs, their engineering team created a beta firmware to test, which after installing appears to have fixed the issue! No information as to how broad this issue is or when the fix might be...

Thanks. It’s still happening repeatedly. I’ll try to contact Hayward. I’ve power cycled OmniLogic as well and also tried enabling the delay using the website but same result. Also looked through the xml config dump and the settings for freeze protect look ok.

For several years, I’ve used the 60-120-180 minute override option via app to temporarily disable freeze protect on one or more of my pumps. This year, I’m finding that when I override my spa pump (secondary single speed pump in this case), it remains disabled indefinitely (e.g. not just for...

Anyone become aware of a way to upgrade the original Vgreen EVO to support automation / Century Connect? Is there a part number to replace the circuit board?

Quick update -- managed to get in touch with their lead engineer; they pushed a firmware update to address some of the variations and also sent me a new cassette and a specific test kit to help further troubleshoot my CYA results. Impressed with the follow up and sounds like they are definitely...

Welp, I ended up ordering an S2 last week and it's been installed for 4 days now. My results thus far for the new C5 have been mostly inconsistent vs my Taylor testing. Over the first 4 days: CH: 235, 442, 393, and 517! My Taylor testing is consistently around 350-375. I guess I'm supposed...

Thanks for the insight! Could you also explain the cartridge swap and test frequency options on the S2? I looked at their FAQ and installed the app but it didn’t answer my two main questions and I suspect others may want to know as well: Can you choose to test less frequently than daily to...

So in case anyone has this issue - I implemented a workaround using interlocks. Set the Spa Jets pump on/off status to match the spa filter pump, then disabled freeze protection on the Spa Jets pump. I lose the independent control but now I can override freeze protection on both together. Now...

On our Omnilogic setup, I can override / disable freeze protection temporarily (1-3 hours) for both our Pool Filter pump and the Spa Filter pump in the app. However, our spa has a second pump for the Spa Jets and if I try to override this pump, the app returns a message that it can't be disabled...

In short -- Where is Omnilogic pulling the displayed temperature and weather conditions from? And where do I see the reading from my actual air temperature sensor that controls freeze protect? Right now for my system: In the Omnilogic iphone app, in the upper left corner of the screen it shows...