Recent content by scchristy

Interesting thing about the polaris replacement is that I no longer feel like I'm going to break the lid when I close it. Otherwise it's exactly the same. Except the replacement came with a caddy, which was a nice bonus.

For those who've experienced issues with the robot...sometime during the last quarter of last year it had the issue I've seen posted here where it would go forward a few feet, rotate (I think 180 degrees...it's been a minute) than go forward a few feet and repeat. I took it to Leslie's and...

Leslie's repaired mine but then it had another problem shortly thereafter. They repaired it again. I don't think it's ever worked as well since the first repair. I plan on calling Fluidra next to see if there's any help there.

So mine has just started doing the thing you've complained about. Also purchased from Marina. It sounds like I should try to reach out to my local Leslie's and hope they are able to do the repair. Did you happen to get a good contact at Flurida? Would be nice to reach out to a warm body.

I tried a Wybot M1 Ultra from kickstarter. Now it was a disaster in many ways, but it had no trouble getting the acorns and filling up the basket.

After speaking with Margaret at Marina I'm thinking of getting the 614iQ, but I'm concerned about the size of the basket. We have a red oak that drops an absurd amount of acorns and leaves in the fall and the spring and the pictures I can find make the basked seem rather small and angled as...

Thanks that's helpful. It's wired to my Intex but currently always on similar to my new vsp.

Maybe it's cycling. Still going now. But salinity now (not the average) shows 2820. Which is an interesting continual drop from when I power cycled. Would be nice if there was a indication it was in the middle of a duty cycle.

I believe it was showing volts but no amps. And no gas. When I cycle power it restarts and produces gas. I did notice this last time that the salinity now reading started at 3400 and over a couple minutes time went down to 3000. It's been about 10 minutes and I just checked again and still...

It was 50% then I switched to 25%. Do you recall if there's a light for duty cycle? The generate light was on. No other lights

So I've just converted over to swg and had an RJ45+ installed (need to update signature). I waited 24 hours after adding initial salt and was reading 3400 using the 1766 kit. New vsp pump running 24/7. The swg was generating first day with no issues. Second day I've noticed twice now that the...

That rationale makes sense. I ended up ordering Rj-45 the other day.

Why don't cells last as long in Texas?

I'm about to order an RJ45 and will have a local pool guy do the install, but I was hoping y'all could comment on whether there's enough pipe there to install it horizontally or if I need to order the vertical installation kit at the same time I order the RJ45. I think part of my confusion...