Recent content by sanspeur

Thanks!

So any of the JP2, JP3 or JP4 can be connected to the motherboard Comm port J4 or J5. OK thanks. I have two wires (a green and a yellow data cable) double connected on the same connector on the intellichlor connector. Should they be moved to one of the other comm ports on the intellichlor board?

Hello. What is supposed to be connected to JP2 and JP4 in an Intellicenter IntelliChlor SCG circuit board?

I was able to repair it in so far as I can tighten (to then point where the magic lube is forced out), but not torque the screws. I used magic lube all around and then tested the spa. Once it goes from pool only to Spa only, still not getting basket full and flow seems to be inconsistent but...

@ajw22 Fantastic! I'll give this a go! Thank you!!

Pic of the suction side. The three red circles are the screws that I cannot tighten. The valve as pictured is in pool mode.

I have a suction side 3 way valve where I just replaced the the gaskets and valve door because I was having an air problem. When in pool mode I have no air in the pump view window. When I switch to spa mode I am not able to fill up the the filter and I loose suction, eventually causing the...

Hi @JamesW, thanks for this. Unfortunately I don't think this is the same as mine as mine does not have any threads to screw into the niche that it came out of :unsure: Could that part be stuck in the actual niche??

@RDspaguy incidentally what does "CPO" in your sig mean?

@RDspaguy Hello. Here is what it looks like...

Hi all. The other day I was going outside to brush the pool and when I got to the spa one of the jet nozzles was laying in the bottom of the spa! See picture of nozzle. How do I put it back in? There does not seem to be any threads to screw it in, or any clips per se to clip it in there...