Recent content by sadpoolguy

Hi MooreND23- The 'Thumper' is a mechanical device within the lamiinar jet that works to create a break in the water stream for the shortest period. It creates a spot in the light stream.

Looks like the J2? Com port is bad and needs to be replaced. Bad news is it’s on national back order.

Yes. But I can’t find where to set that.

As always, Thanks Jim! I didn't wait 5 seconds to take the pic after I put it in Service Mode. That would explain why it looks the same. I'll call Pentair Monday and see if they will ship me a replacement cable. The PB didn't trim the cable, so there is 20' or so in the side of the panel. I...

Jim - I checked all connections. They are tight. This may be a chip issue.

The Superflo label was for the first VST. Sorry. They are incorrect. It should say intelliflo as it was replaced. Dang it.

Service mode displayNormal mode pump displayBreaker labels I assume they are correct so it should have continuous power

My easytouch system keeps loosing communication with the intelliflo and the intellichlor. Normally this is just an inconvenience but with the continuing freezing temperatures it’s a potential disaster. The pump shuts down when it looses communication. This happens about every two weeks. I...

Well, it's a month later. We are still working on the pool. PB 2.0 has COVID, so all work has stopped again. Looks like most, if not all, of the leaks have been found and corrected. Tried the SPA out finally. I have to admit, I am VERY glad we added it to the project. I watched the 1st...

Jim I have a Pentair Intellitouch control system. I have 4 Magic Stream Laminar Jets and 8 LED lights, all on 1 transformer. I am trying to use the built in pre-programmed light colors and color sequences with the lights. Treo said it's impossible and will not work. The engineer at Treo said...

According to they tech guy at SR Smith Pentair uses electrical pulses to change light color, not off/on.