Recent content by SacPoolPros

Also, that wall needs to be waterproofed front and back or its going to bleed through tile

If you don't already have engineering for this then that's a problem

Acid bath lower pH below 7.0 use a sump pump to move water around and brush for 3-4 days will comes off or do a drain and acid wash

Pretty typical we use stonescapes on about 600 pools a year anything with black pebble depends on what quarry it comes from, but it can vary quite a bit.

As a Gunite company owner these cracks are just surface shrinkage cracks completely harmless all concrete cracks you'll get similar ones on your decking plaster will fill it those are to small to even accept filler especially when vertical proceed to plaster no worries at all.

I'd be willing to bet those cracks go away once the pool is full of water this happens on most plaster jobs it's just shrinkage cracks once the plaster is hydrated they will close up and go away.

There estimate literally states. that they didn't chip the plaster out they just pressure washed it to "rough" it up and went over the old surface. i have countless videos of jobs we have re-done because they have hollow spots everywhere 3-6 months down the road over this.

I specialize in the Quartz Product. We do about 10 installs a week of this product, it does not look like the proper steps were taken once it was installed. First off night photos are where you are going to see many imperfections in any finish that is normal no surface is going to be completely...

The gear box i have a few here at my shop let me open one up and try too send you a video

Those mixing valves are fun to work with. I'd open it up and check if any debris is trapped in it. I've had the smallest debris get trapped inside and make it so that it won't cycle properly.

IQ20a doesn't work on mesh networks. you'll need to upgrade to the new IQ30a which can talk to mesh networks.

The heat pump should be plumbed off your filter pump so it should always have filtered water no need to have a separate suction and return for it.

Do you have an IQ30a or IQ20a? that would be the antenna.

As a builder, this is pretty normal the deck looks like it's having efflorescence issues which is normal and not a structural issue or warranty issue. Probably poured when it was pretty wet out and lots of moisture in the ground, I'd give it time to dry out and then look at it. As for the...

You can see all the dust build up nothing has even been brushed yet. brush pool you'll be fine