Recent content by RoxanneIsNumber1

Ok sounds good. I have a pool company coming out to install a pentair automation system. I'll have them look at the plaster :( I'm hoping it's not serious.

@onBalance oof serious issues? oh no! What do you think the issues may be? i have the chipped off pieces still so I was thinking of gluing them back together then putting it back. Will the E-Z Patch fix the pop-outs too? There are maybe 3 of 4 small divots in the pool/spa.

Hi guys. My spa step chipped and don’t know what to use to repair it. Is there a specific glue? Can I do it under water? Or do I have to make the water level lower? I also have some pop outs (is that what they’re called)? Would I be able to use the same fix?Is it same for the grout that is...

Hi Bama, Thanks for your reply! I'll take clearer pictures Wednesday night when I get home. I really wish I knew which appliance module is missing. I remember the remote control had labels for spa light, pool light, bubbles, pool, heater, spa. I'm assuming pool and spa were to control the...

Hello TFP, So the X10 RF modules went out and it's too costly to replace the parts (actuators went out, modules went out, and remote went out). I would like to replace this with single pole switches, but require some assistance. I don't really understand how the black relays in he middle...

Hi Jbizzle, is there one you can recommend? I see a couple of different ones made by different manufacturers. I'll update my signature once I find out my measurements and what it's made of. Thanks in advance

Does anyone know where I can find this ram bit? I've went to my local Home Depot and they don't have anything like this. They actually went and laughed at me :(

Hi Jblizzle, Thanks for replying. I wish I had known about that ram bit before I hacked the plumbing apart on the return side. I'll go see if my local Home Depot carries it. I'm familiar with wiring light switches, so that gives me some confidence to wire it, but I'm not too sure how I could...

Hello TFP, I have a pool that came with the house I purchased which was built in 1999. The old automation system is an X-10 with Ortega valves/actuators and an old Sta-Rite heater (which also failed). I'm in the process of converting the Ortega valves into the Hayward 3-way diverter valves...

is this still available?