Recent content by robert1906

  1. R

    Adding Muriatic

    Thank You
  2. R

    Adding Muriatic

    Thank You
  3. R

    Adding Muriatic

    Need 59oz of Muriatic Acid to my pool? Can I add it all at once? Does it need to be diluted or can I add directly from bottle?
  4. R

    Front Wheel not touching Idler wheel

    Thank You
  5. R

    Front Wheel not touching Idler wheel

    Hello, how do you adjust the wheels on a Polaris 280. On the side where there are 3 wheels the back wheel is touching the idler but the front wheel on the drive shaft is not. Is there a way to adjust the idler or front wheel so that there is contact? Went to Leslie pools and they want to...
  6. R

    CH

    I apologize as I need to raise my CH and not reduce it. My CH reading is 130. 22,000 gallon plaster pool
  7. R

    CH

    Are there any home products that will decrease CH?
  8. R

    High PSI

    This 1st slam process has not gone the way I expected but it was a learning experience. I'm at the point of no return regarding $$$ as I've had to purchase a couple of filters and the center core the filter goes on. The high PSI blew out the filters and cracked the center core I to several...
  9. R

    High PSI

    J x Sent from my SM-N920V using Tapatalk
  10. R

    High PSI

    Jim, I reread my post and should have said new filter cartridge as opposed to new filter (sorry). I have a pentair clean and clear filter and yes it only has one filter. The water is green and the cartridge is blue. I can see the debris from the pool coming 9ff of the cartridge when cleaning...
  11. R

    High PSI

    I just purchased a new filter that I installed and ran for approx 15-mins on Sunday May 22nd 2016.. WIthin 15 mins of turning on pointthe PSI jumped from below 10 to 25psi and then +30psi. Since I had been slamming another member advised that the PSI moves up quickly doue to all dead algae...
  12. R

    Restarting a Slam

    Thanks.. headed to strlory to get a stabilizer Sent from my SM-N920V using Tapatalk
  13. R

    Restarting a Slam

    CA above should be CYA 0... Sent from my SM-N920V using Tapatalk
  14. R

    Restarting a Slam

    Was out of town last week and with the storms of Texas I returned to a dark green pool again.... I measured my chemicals and here are the results Chlorine 0, CH 200, CA 0, TA 100 and pH 8.0. I have the acid to lower the pH but wanted to know if I need to raise my CYA from 0 before I start...
  15. R

    Choosing a new pool filter.

    Appreciate the help... I'll look tomorrow... Sent from my SM-N920V using Tapatalk
See more
Top Bottom
Back